My experience on adding a SSD to an old laptop and copying Windows System Partition
Hardware
- Existing
- Acer 5745 with 8 Gb RAM / DVD / 500 Gb HDD
- Upgrade
Universal 12mm Laptop Optical Bay Hard Disk SATA to SATA 12.7mm HDD Caddy costing INR 750
- This product is available from seller sitetechnologies.in on ebay.in
- Bought a SSD 128 Gb from flipkart @ INR 4240
- Acer 5745 with 8 Gb RAM / DVD / 500 Gb HDD
- This product is available from seller sitetechnologies.in on ebay.in
- Bought a SSD 128 Gb from flipkart @ INR 4240
Universal 12mm Laptop Optical Bay Hard Disk SATA to SATA 12.7mm HDD Caddy costing INR 750 |
My Experience
- Backup
- Used Macrium Reflect to take an image of my C drive (System partition) which contained my Windows 7 OS on an external drive
- Choose Disk Image and then select the desired System partition
- Create the Image on the external Media
- Also created the Windows Recovery Media on a USB device
- I used a SD Card of 4 gb
- Choose Other Tasks -> Create Rescue Media -> windows PE
- Fixing the SSD
- Opened my laptop (rear 8 screws) and removed my HDD and fixed the SSD in it's place.
- Restore
- Connect the external HDD containing the System Image
- Connect the Windows PE media ( In case my SD Card)
- Started my laptop and choose the F2 / F12 key to start boot from my SD Card (USB)
- Windows PE rescue will start.
- Choose the Restore Image option
- Choose the Source as the Image from the external Drive
- Choose Target as the SSD Drive
- Complete the Restore and shutdown
- Start the Laptop and boot from Windows PE Media again
- Hit Esc to stop the Windows PE from going to the Restore Image menu
- Use Fix Windows Boot Problems on the SSD Drive
- Now it will offer to correct the SSD drive
- Write the MBR and Boot info
- You are done
- Reboot and check that the system partition successfully boots
- Fixing the Hard Drive
- Now remove the DVD drive
- Fix the HDD in the Caddy and push it back
- Close Laptop
- Restart the system
Why did I have to shift the Hdd to the Caddy
- My laptop BIOS cannot identify the HDD connected on the DVD port
- Of course you can workaround this by using Windows Restore and create a Boot table which would show both partitions allowing you to boot from either